91在线无码精品秘 入口色,寡妇高潮一级毛片免费看按摩店,丰满放荡岳乱妇91WWW,免费av网站在线观看,国产一级a毛一级a看免费视频

當前位置:網站首頁技術文章 > 介紹日本SMC高壓電氣比例閥安裝方法

產品列表 / products

介紹日本SMC高壓電氣比例閥安裝方法

更新時間:2019-09-06 點擊量:714

1、先要檢查電磁閥是否與選型參數一致,比如電源電壓、介質壓力、壓差等,尤其是電源,如果搞錯,就會燒壞線圈。電源電壓應滿足額定電壓電壓波動范圍:交流+10%~-15%,直流+10%~-10%,平時線圈組件不宜拆開。 

2、一般電磁閥的電磁線圈部件應豎直向上,豎直安裝在水平于地面的管道,如果受空間限制或工況要求必須按側立安裝的,需在選型訂貨時提出。否則可能造成電磁閥不能正常工作。 

3、接管之前要對管道進行沖洗,把管道中的金屬粉末及密封材料殘留物,銹垢等清除。要注意介質的潔凈度,如果介質內混有塵垢,雜質等妨礙電磁閥的正常工作,管道中應裝過濾器或濾網。 

4、如果介質會起水錘現象,那么應該選用具防水錘功能的電磁閥或采取相應的防范措施。 

5、電磁閥前后應加手動切斷閥,同時應設旁路,便于電磁閥在故障時維護。